
FAA20 Embedded NEXCOM Vocoder
Board Manual
This manual has been prepared for the Federal Aviation Administration.
FA100-00107 (March 2004) – Rev 1.0.0 Page 90
8.3.25 OPMODE
The OPMODE command sets/gets the operational mode. The operational
mode is configured at power up based on switches SW7 and SW8, i.e. it is
not a flash parameter. The mode can be changed after power up with the
OPMODE command.
Table 36: OPMODE Command Syntax
ATTRIBUTE DESCRIPTION
SYNTAX OPMODE [mode]
PARAMETERS mode Operational Setting.
NORM = Normal Mode (supports expanded feature set)
VC20 = VC20 Emulation Mode (quick compatibility)
DEMO = Demo Mode (standalone operation)
TEST = Test Mode
FLASH NO
Print current OPMODE setting (initial setting configured by SW7/SW8)
COM1: opmode
> OPMODE = NORM
EXAMPLES
Change mode to DEMO mode.
COM1: opmode demo
> OPMODE = DEMO
For more information, see Section 5.1
Comentarios a estos manuales