Digital Voice Systems VC-20-ATC-10B Especificaciones Pagina 71

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 109
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 70
FAA20 Embedded NEXCOM Vocoder
Board Manual
This manual has been prepared for the Federal Aviation Administration.
FA100-00107 (March 2004) Rev 1.0.0 Page 65
8.3.3 CFG
The CFG command displays a list of important FAA20 configuration
settings. It is also used to save and restore flash parameter settings.
When CFG parameters are displayed, all important settings are displayed,
not just the flash configuration parameters.
Table 14: CFG Command Syntax
ATTRIBUTE DESCRIPTION
SYNTAX CFG [fparam]]
PARAMETERS fparam Configuration Parameter.
SAVE = Saves settings to flash memory.
RESTORE = Restores settings from flash memory.
DEFAULT = Sets FAA20 to factory default.
Note: The SAVE and RESTORE parameters access the
flash, but the DEFAULT parameter does not.
FLASH The CFG command reads/writes flash memory.
Save parameters to flash.
COM1: cfg save
> CFG SAVE OK
Restore parameters from flash.
COM1: cfg restore
> CFG RESTORE OK
Setup FAA20 to factory default.
COM1: cfg default
> CFG DEFAULT OK
EXAMPLES
Request current configuration information (default settings shown).
COM1: cfg
> ADAPT = ON
> CLKRATE PCM NORM = 3840000
> CLKRATE PCM TRUN = 3840000
> CLKRATE NIB NORM = 9600
> CLKRATE NIB TRUN = 9600
> CLKREF = AUD
> CLKSRC PCM = INT
> CLKSRC NIB = INT
> COMCFG COM1 = 115200,8,1,N,D
> COMCFG COM2 = 115200,8,1,N,D
> COMECHO COM1 = ON
> COMECHO COM2 = ON
> COMECHO COM3 = OFF
> COMPROMPT COM1 = ON
> COMPROMPT COM2 = ON
> COMPROMPT COM3 = OFF
> FRAMESIZE PCM NORM = 480
> FRAMESIZE PCM TRUN = 480
> FRAMESIZE NIB NORM = 192
> FRAMESIZE NIB TRUN = 230
> GAM AUD TX = 0x1000
> GAM AUD RX = 0x1000
> LED 1 = LANYP
Vista de pagina 70
1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 108 109

Comentarios a estos manuales

Sin comentarios