Digital Voice Systems VC-20-ATC-10B Especificaciones Pagina 56

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 109
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 55
FAA20 Embedded NEXCOM Vocoder
Board Manual
This manual has been prepared for the Federal Aviation Administration.
FA100-00107 (March 2004) Rev 1.0.0 Page 50
be pressed to restore the command prompt. The file transfer can be
initiated again by beginning again at step #3.
5. Enter the RESET command to force the FAA20 to load the new
program.
After a few seconds, the FAA20 restarts and prints the banner
message providing the new software build details. Note: If the new
software erases the configuration block (see step #2), the FAA20
prints a configuration memory error, i.e. “ERR FLASH_CFG - using
default”.
6. Reconfigure the FAA20, as necessary, using the information
recorded in step #2.
Figure 22 provides a sample terminal programming session.
Figure 22: Software Upgrade (Standard Mode)
COM1: comcfg
> COMCFG COM1 = 115200,8,1,N,H
> COMCFG COM2 = 115200,8,1,N,D
COM1: prog
> ERASING FLASH (wait for READY)
> READY
> #Records = 1472
> DONE
COM1: reset
> RESET OK
COM1:
Booting...!
> ********************************************************************
> * FAA20: AMBE 4.8 kbps Vocoder (for Air Traffic Communication) *
> ********************************************************************
> Copyright 2004. CIE Engineering, Inc. All rights reserved.
> For more information, contact: www.cie-eng.com
> Version: 1.0.0
> Built: Feb 18 2004 15:53:17
> Serial#: 617
>
> Type ? for help
COM1:
Vista de pagina 55
1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 108 109

Comentarios a estos manuales

Sin comentarios