
FAA20 Embedded NEXCOM Vocoder
Board Manual
This manual has been prepared for the Federal Aviation Administration.
FA100-00107 (March 2004) – Rev 1.0.0 Page 64
BITNAME ATTRIBUTES* DESCRIPTION
DDET RW, CL, RSVD DDET Signal Control Bit (DTMF Detect). Reserved for
future use.
GO RO, CL GO Signal Input State. Displays the current state of
the GO input signal.
VAD RO, CL VAD Signal Input Bit (Voice Activity Detect). Displays
the current state of the VAD input signal.
ECHO RO, CL ECHO Signal Input Bit. Displays the current state of
the ECHO input signal.
TMTX RW, SWC, CL Truncated Mode Status Bit. When set, it indicates that
the TMTX signal is active (high).
Note: For all operational modes except the TEST
mode, this bit is software controlled.
TMRX RO, CL Truncated Mode Control Bit. When set, it indicates
that the TMRX signal is active (low).
XOE RW, RSVD Expansion Output Group Enable. Reserved for future
use.
TS2 RW, SWC,
RSVD
Time Slot Enable. When set, it enables two PCM
slots. Use of this bit is reserved for future expansion.
CS1 RW, SWC,
RSVD
CPLD Clock Mode Bit #1. This bit is reserved for
factory use.
CS0 RW, SWC,
RSVD
CPLD Clock Mode Bit #0. This bit is reserved for
factory use.
X03 RW, RSVD Expansion Bit #3 State. Reserved for future use.
X02 RW, RSVD Expansion Bit #3 State. Reserved for future use.
X01 RW, RSVD Expansion Bit #3 State. Reserved for future use.
X00 RW, RSVD Expansion Bit #3 State.. Reserved for future use.
X03E RW, RSVD Expansion Bit #3 Output Enable. Reserved for future
use.
X02E RW, RSVD Expansion Bit #2 Output Enable. Reserved for future
use.
X01E RW, RSVD Expansion Bit #1 Output Enable. Reserved for future
use.
X00E RW, RSVD Expansion Bit #0 Output Enable. Reserved for future
use.
DINR RO DINR Signal State. Displays the state of the DINRS
signal.
SPRD RO SPRD Signal State. Displays the state of the SPRDY
signal.
RTS1 RW, SWC Request-to-Send Signal (COM1).
CTS1 RO Clear-to-Send Signal State (COM1).
DTR1 RW, SWC Data Terminal Control Signal (COM1).
DSR1 RO Data Send Ready Signal (COM1).
RTS2 RW, SWC Request-to-Send Signal (COM2).
CTS2 RO Clear-to-Send Signal State (COM2).
DTR2 RW, SWC Data Terminal Control Signal (COM2).
DSR2 RO Data Send Ready Signal (COM2).
* RW = Read/Write, RO = Read Only, SWC = Software Controlled, RSVD = Reserved, CL = Clock
Latched
Comentarios a estos manuales